Laars Heating Systems T2017200 Tile 322056-301 a 500-ohm resistor must be

a 500-ohm resistor must be installed across the input terminals to convert the current signal to the appropriate voltage range

it is the standard replacement burner used in both natural gas and liquid propane Williams furnace assemblies when paired with the correct orifice

Broad Compatibility: Standard 1/4 inch spade terminals allow for seamless integration with existing control board lead wires

verify the water flow rate and actual tank temperature before replacing the sensor

Always verify the part number LB-94723D against your unit's nameplate

Laars Heating Systems T2017200 Tile 322056-301 a 500-ohm resistor must beThe Laars Heating Systems T2017200 Rear Center Tile is a critical replacement component for high output Laars Pennant boilers and volume water heaters. Designed specifically for the Pennant series, including models ranging from the 1250 to 2000 (both LP and NG configurations), this refractory tile serves as a focal point for heat management within the combustion chamber. By acting as high temperature insulation, the Laars T2017200 directs thermal