FYSETC Clone Duet 3 Toolboard 1LC V1.1 A CAN-FD four wheel drive Supports up to 8 stepper

Supports up to 8 stepper motors at up to 60 volts via a range of compatible drivers in UART/SPI modes

Storage Condition: -20~60℃

Operating Current: 360mA

Mega 2560 uses pin 52 #define FSYNC 10    // SPI Load/SS pin number

Automatic Shutdown: Off * 3 minutes/5 minutes/10 minutes

FYSETC Clone Duet 3 Toolboard 1LC V1.1 A CAN-FD four wheel drive Supports up to 8 stepperThe Clone Duet 3 Tool board is a CAN FD connected expansion board for the Duet 3 Mainboard that is designed to provide complete control for a direct drive extruder, associated fans, filament sensor and probe. The mounting holes and connector locations match an e3d Hermera, however it can be used with other direct drive extruders with suitable brackets. The stepper motor, heater, temperature sensor, fans and optionally Z probe and filament monitor all